Cdm9з”µжњєзљ„зј–зё‹пј€vlпј‰.mov -

If the door uses a pneumatic seal (bottom gasket), ensure a solid floor surface is available; without a floor or obstruction, the machine cannot calibrate the stop position. 3. Programming Procedure ("Programming the Road")

Locate the SW1 switch (typically next to the red LED) and turn it ON . CDM9з”µжњєзљ„зј–зЁ‹пј€VLпј‰.mov

Verify the connection block X1:7 (low voltage neutral) and ensure nominal voltage is within ±10%. If the door uses a pneumatic seal (bottom